Pool / Create Project | Site Plan Ace

Residential Swimming Pool Plan Review Worksheet

Use this worksheet to document the plan-review checks for a residential swimming pool and associated equipment. Select a status for each item and add plan-sheet references or correction notes.

1. Project information

Project address

Applicant / contractor

Permit / application number

Reviewer

Pool type

Code edition / local amendments

2. Electrical and equipotential bonding

Equipotential bonding provided in accordance with CEC Article 680?

GFCI-protected receptacle provided in the 6–20 ft zone?

No receptacles located within 5 ft of the inside pool wall, where prohibited?

GFCI protection provided for pool lighting circuits where required?

Metal parts within 5 ft horizontally or 12 ft vertically addressed for bonding?

Disconnecting means for pool pump provided and located as required?

3. Energy and electrical load documentation

CF2R pool form provided if required by the AHJ?

CEC 220.40 load calculation for added loads provided if required by the AHJ?

4. Pool heater and gas scope

Pool heater proposed?

Heater fuel source

Heater shown on plans?

If applicable, heater on plans matches CF2R form?

Gas requirements / other gas-fired site features

If natural gas or propane is selected, review gas piping and equipment requirements. Refer to the applicable gas permit and plan-review requirements for any heater or other gas-fired features on site.

5. Structural and site conditions

Structural details included in the plan set?

Pool within 7 ft of a descending slope, with soil support addressed?

Pool within the influence line of an existing structure foundation, with soil support addressed?

Glazing within 5 ft of pool addressed for required safety glazing?

6. Pool equipment panel / feeder

Separate pool equipment panel proposed?

Feeder conductor size / material

Feeder allowable ampacity (A)

Feeder overcurrent device rating (A)

Calculated feeder load (A)

Pool equipment panel bus rating (A)

Pool feeder checks

Feeder OCPD versus calculated loadEnter feeder load and OCPD.

Feeder conductor ampacity versus OCPDEnter conductor ampacity and OCPD.

Panel bus rating versus feeder OCPDEnter panel bus and OCPD.

Feeder / panel notes

7. Review summary

Items marked Yes0

Items marked No0

Not reviewed0

Review reminder: This worksheet is a plan-review checklist, not a substitute for checking the adopted CEC, CBC, CRC, Energy Code, local amendments, equipment listings, or project-specific engineering. Confirm the precise applicability and measurement points for each dimensional requirement. In particular, evaluate receptacle and bonding clearances against the applicable CEC 680 provisions rather than relying solely on a generalized distance entered here.